TC Electronic G-Force, User Manual

Page: 28 / 60

Dial Value to set On/Off
Press Enter to enter
modifier
Selected
Modifiers
This is the display where you set up the parameters for the internal modifiers. Use the Parameter wheel to select the
modifier you want to edit and press Enter to access the parameters of the current modifier.
Pressing Enter will enable you to enter into the current selected
Modifier. Here is an explanation of the parameters in the
Modifiers.
Envelope Follower
The Envelope follower is used on effects that you would like to
respond to the input signal like touch-wah or dynamic delay. The
Envelope follower will perform the same dynamic movement as
the input, but you can change the response time by using the
Attack and Release.
Attack - Sets the amount of time before the ENV
reacts to the input signal.
Release - The time that the ENV continues to
work after the input signal stopped.
ADSR 1&2
ADSR’s are used to play short sequences triggered by the audio
input. You set up a number of terms to describe the current
sequence, and a trigger level also known as Threshold.
Attack
The Attack or rise time of the curve i.e. how long it takes to go
from minimum to maximum level.
Decay
Sets how long it takes the curve to fall back from maximum to
Sustain level.
Sustain
The amount of time that the ADSR will hold the Sustain level.
Sustain level
The value that will be sent out during the Sustain period.
Release
The amount of time that it takes the ADSR to fall from Sustain
level to zero. Release time will take over when the Sustain time
has expired (depending on the trig mode setting).
Mode
With the mode parameter parameter you can choose the way the
ADSR should respond to trigs. In general the ADSR can only
retrig if the signal falls below threshold and comes back up.
Once -
Will run the ADSR to the end once, and after
that be ready for a new trig. In “Once” mode
the signal have to drop below threshold after
the ADSR finished to be able to retrig.
Once-Retrig - Will run the ADSR to end once, but are
capable of retriggering during the ADSR
sequence.
Loop - Will keep running the ADSR sequence for as
long as the signal stays above threshold.
Loop-Retrig - Will keep running the ADSR sequence for as
long as the signal stays above threshold, but
are capable of retriggering during the ADSR
sequence.
MODIFIER
28