TC Electronic G-Force, User Manual

Page: 42 / 60

THE BLOCKS
40
If the Feedback parameter is set to 100%, the
G-Force will loop Delay signal. Connect an
Expression pedal and check out preset 174 and 175
for a start.
Lowcut
Cuts off frequencies lower than the selected frequency. The
slope of the filter is 12dB/octave.
Highcut
Cuts off frequencies higher than the selected frequency. So if
you feel that there is too much treble in your signal, you
remove this by adjusting the highcut filter down. The slope
of the filter is 12dB/octave.
Mix
Mix between direct sound and effect.
Connect this parameter (Mix) to the Envelope
follower in the Modifier Matrix to create dynamic
delay.
In Level
Controls the input level of the block.
Out Level
Controls the output level of the Delay block.
Mute mode
See Mute mode in the introduction of this chapter.
DUAL DELAY
Time 1
Sets the delay time of the first Delay tap. Maximum delay
time is 740 ms.
Time 2
Sets the delay time of the second Delay tap. Maximum delay
time is 740 ms.
Tempo 1&2
The Tempo parameter sets the relationship to the global
Tempo e.g. if you set it to 1/4T you will get quarter note
triplets of the tapped tempo. 1/4 equals the BPM (tapped
Tempo).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global Tempo.
Feedback 1 to 1/Feedback 2 to 2
Sets the amount of feedback from Delay 1 to 1 and from
Delay 2 to 2.
NOTE: The sum of the four feedbacks is limited to 100%.
Feedback 1 to 2/ Feedback 2 to 1.
Sets the amount of cross feedback from Delay 1 to 2 and
Delay 2 to 1.
Levels
Sets the level of each of the two delay lines.
Pan 1-2
Controls the panning of the two Delay taps.
Connect a LFO to one or both of these parameters
and you have an extra autopanner.
Lowcut 1-2
Cuts off frequencies lower than the selected frequency. The
slope of the filter is 12dB/octave.
Highcut 1-2
Cuts off frequencies higher than the selected frequency. So if
you feel that there is too much treble in your signal, you
remove this by moving the highcut down. The slope of the
filter is 12dB/octave.
Mix
Mix between direct sound and effect.
In Level
Controls the input level of the block.
Out Level
Controls the output level of the Delay block.
Mute mode
See Mute mode in the introduction of this chapter.
DUAL TWO TAP DELAY