TC Electronic G-Force, User Manual

Page: 23 / 60

Control
Select setup bank
Model
Copy to bank
Main vol.
Bypass
Tuner
Tempo
Ext 1 - 8
Gate (Gate)
Cpr (Compressor)
Fil (Filters)
Pan (Pan+Tremolo)
Pit (Pitch)
Dly (Delay)
Drv (Drive)
Cho (Chorus)
Rev (Reverb)
Effect bypass
Modifier input
G-Force control
Board factory defaults
Setup bank
Press Enter and
move your pedal
for auto-detection
I/O SETUP
23
Disabled - Will cause the G-Force to ignore any incoming
program change.
Preset Recall - Will enable the G-Force to use program changes
sent on the “Basic channel”.
+ Partial Recall - When this value is selected, the G-Force will
still respond to program changes sent on the basic channel, but at
the same time each of the eight effect blocks will have their own
MIDI channels enabling you to recall a single block without
affecting the rest of the preset. The channel numbers of the
blocks are continuous from the Basic channel.
Example: If the basic channel is set to 1, the blocks channels will
be Compress ch. 2, Filters ch. 3, Pan ch. 4 etc.
Bank Selection
This function is a new MIDI standard, making it possible to
Recall presets above #128. The parameter determines whether
the G-Force should respond to this message or not. If your MIDI
device or foot controller is capable of using this function, you
should select Fine or Coarse.
(Please refer to your MIDI device/Foot Controller owners manual
to make sure which type the current product is using).
If set to disabled, the G-Force will act as a standard MIDI
product.
Bank size
The bank size is used to adapt the G-Force to different board
manufacturers when recalling preset above #128. In most cases
this parameter should be set at 128, but in some cases e.g. when
using the Roland FC-200, it should be set at 100.
The bank selection number contained in the program change is
multiplied with this value and the program change number is
added.
Please refer to the manual of the board manufacturer for proper
setting.
Sysex device ID
The Sysex ID of the G-Force.
Program change offset
With this parameter you are able to add or subtract to or from the
incoming Prg. change; e.g. the incoming Prg. change is preset
123, and the offset is set to +1, the Prg. change will now be 124.
The G-Force presets start at #1.
Mapping mode
Adjusts which bank the MIDI mapping should use: ROM,USER,
CARD or Custom. This means that you can guide an incoming
Prg. change to use the USER bank, or you can design your own
MIDI map.
MIDI
Basic channel
Program change
Bank selection
Bank size
Sysex device ID.
Program change offset
Mapping mode
Map program ch. no.
Into Preset
Reset Custom Map
Custom map
Program change map
Global MIDI settings
Custom Map
In the Custom Map you can decide what every incoming Prg.
change should map to, using the “Map Program Change No.”
and the “Into Preset” parameters.
Map Program change no.
Use this parameter to select the Prg. change you want to remap.
Into Preset
Use this parameter to set the new destination of the incoming
program change.
Reset Custom Map
Place the cursor on this parameter and press Enter to Reset the
Custom map.