TATA Motors nano genX, Owner'S Manual

Page: 107 / 156

105 105
MAINTENANCE
ENGINE COOLANT LEVEL
The coolant level in the coolant no-
loss tank should be between max.
& min. marks. This can be viewed
through a translucent reservoir. If
less, add coolant up to the max. mark
and refit the cap properly.
NOTE
Check coolant level in the radiator,
by opening the pressure cap
(ensure vehicle is in cold
condition). If coolant level is seen
below filler neck top, then add
specified pre-mixed coolant
(60:40).
Check coolant level in ‘No-Loss
(Reservoir) tank, if lower than the
ENGINE COOLANT LEVEL
MAX leve, then add specific
premixed coolant (60:40) upto
refill level.
NOTE
•
Do not use only coolant or plain
water.
•
Do not add extra inhibitors or
additives. They may not be com-
patible with your cooling sys-
tem.
•
Do not mix different types of
base coolants. Doing so may
result in accelerated seal wear
and/or the possibility of severe
overheating and extensive
engine damage.
NOTE
Check radiator fins for dirt/dust
accumulation. Get it cleaned from
nearest
TATA MOTORS
Authorised Workshop if required.
NOTE
If ‘No loss’ tank is found
completely empty, top up coolant
through radiator as well as
auxilary tank cap.
CAUTION
Never remove the filler cap when
the engine is hot. Use only
branded premixed ready to use
coolant. In case of emergency
use normal water only. When a
proper coolant mixture is
available, the entire system
should be flushed & filled with the
same at the earliest.
(FOR AMT)