Tandberg Data M-Series Installation Guide
Document T6423046-02 A01
February 2004
Installing a Rack Mount Library
29
7
Insert a #2 POZIDRIV screwdriver into the hole and turn the rack mount
clamp screw clockwise to tighten it.
As you tighten this screw, a lever protrudes from the side of the library
and presses against the back side of the rack rail.
8
through
to secure the right side of the library to the rack.
9
Close the magazine access doors.
Proceed to
Installing Drives in the Library
installation procedure.
Installing an M2500
0
To install an M2500 in a rack:
1
Take precautions to ensure that the rack is stable:
• If you are installing the library at the top of a rack with no equipment
at the bottom of the rack, purchase a rack stabilization kit from the
rack manufacturer and install it before installing the library.
• If you are installing the library in a rack with other equipment, place
the heaviest equipment at the bottom of the rack.
2
Verify that the rack mount shelves are level and securely fastened to the
rack.
3
With the help of another person, lift the library onto the rack mount
shelves.
4
Slide the library all the way into the rack.
5
Press the two buttons next to the left magazine access doors and open the
doors.
6
Notice the two holes behind the left magazine access doors (see
These holes provide access to the rack mount clamp screws.
Caution:
Do not over-tighten the rack mount clamp screw. When
the screw begins to feel tight, turn it an additional quarter
turn and then stop.
Warning:
The M2500 weighs approximately 152 lbs. (69 kg). At least two
people are required to lift and install the library.