Tandberg Data M-Series Installation Guide
Document T6423046-02 A01
February 2004
Installing Drives in the Library
31
Installing Drives in the Library
0
This section explains how to install tape drives in the library. You will need
the following tools for this procedure:
• #2 PHILLIPS
®
screwdriver (if you are installing drives in an M1500)
• TORX
®
T-20 screwdriver (if you are installing drives in an M2500)
• TORX T-8 screwdriver (if you are installing drives in drive bays 3
through 6 of an M2500)
• Flat blade screwdriver
Installing Tape Drives
in an M1500
0
To install tape drives in an M1500:
1
At the back of the library, use a #2 PHILLIPS screwdriver to remove the
cover plate protecting the drive bay in which you will install the tape
drive.
2
Insert the tape drive into the drive bay slowly until the connectors are
seated (see
).
3
Tighten the tape drive thumbscrew using a flat blade screwdriver.
4
through
to install another tape drive, if desired.
Figure 27 Installing a Tape
Drive in an M1500
Tape drive
Thumbscrew
