Tanco 1400 Autowrap, Operator'S Handbook Manual, Page: 44 / 132

Tanco Autowrap - 1400
Operator’s Manual
43
- Unloading
In ‘A’ (Auto Mode) the machine will run through a full automatic wrapping sequence. One round before
the required number of revolutions is obtained; the speed of the wrapping arm is reduced and the cutter
opens. The wrapping arm passes the open cutter and stops. The cutter closes and the wrapping arm
reverses to the park position. (See Section 7 for making alterations to controller settings).
The Bale is now ready to be Unloaded this can be done in one of two ways; Standard Off-loading or End
Tipping
Standard Off-loading
The rear roller drops down to off-load the bale. Beware of the danger of the bales rolling when working
in hilly conditions, always off load the bale across the hill. The controller allows a number of methods of
triggering off-loading:
If Auto Off-Load is set to ON (Operator Setup) then the bale will be automatically off-loaded at the end of
wrapping. If Auto Off-Load is set to OFF, then press (R5) must be pressed to start off-loading.
8. Operational Features