Tanco 1400 Autowrap, Operator'S Handbook Manual, Page: 32 / 132

Tanco Autowrap - 1400
Operator’s Manual
31
Manually Interrupting an Automatic Wrapping Cycle
Press (L3) to bring the wrapper to a controlled stop. Pressing (R3) will resume the auto-wrap cycle from
where it stopped.
For safety reasons; if it is necessary to work on the machine (e.g. in the event of a film break or the film
running out), then it is strongly recommended that you then switch the controller off via the red stop
button and disengage the machine power source. Pressing the (R3) switch after switching the controller
back on will resume the auto-wrap cycle from where it stopped.
Unless it is an emergency situation, do not bring the machine to a stop by pressing the red stop button
as this will impose unnecessary strain on the machine.
Manual Options in Automatic Mode
With the controller in Automatic Mode, the following manual functions are possible;
- Slow Wrap (not during the wrapping sequence)
If (L3) is held down the arm will stop when it comes to the park position, releasing and pressing again
will move the arm to the next park position.
Press (R3) to resume the normal fast wrap.
- Reverse Wrap Arm (only enabled outside of the wrapping sequence)
Press (L4) to shift the wrap arm backwards to the desired position. As with the slow wrap if this button is
held down the arm will stop at the park position.
- Load Arm Up (on Hand Held Controller)
Pressing the Upwards arrow on the Hand Held Controller raises the Load Arm.
7. Controller Information