Tanco 1400 Autowrap, Operator'S Handbook Manual, Page: 41 / 132

Tanco Autowrap - 1400
Operator’s Manual
40
3 Operational Principles
The controller allows for varying degrees of operator intervention in the control of the machine. It is
possible to set the controller so one press of a button will run a full automatic sequence from loading
to wrapping and unloading. When operating in less than ideal conditions for example when wrapping
badly shaped bales or if wrapping in hilly areas it is advisable to break the sequence into the three
sections;
Loading
Wrapping
Unloading
See below the correct way to preform these tasks;
- Loading
Set the machine into the loading position: (See Fig. 14)
• Move the Drawbar to the full out position.
• Lower the Load Frame to the ground.
• Open the Squeeze Arm fully.
• Ensure the Wrapping Arm is in the park position; ie the Wrap Arm Magnet is positioned under the
Sensor, (See Fig. 16)
Note: The controller will not allow loading if the wrap arm is not in this position.
• Drive up to bale, keeping the Bale Guide close to the end of the bale, commence loading when Load
Frame cross tube is in contact with the bale (See Fig. 15).
8. Operational Features