Tanco 1400 Autowrap, Operator'S Handbook Manual, Page: 38 / 132

Tanco Autowrap - 1400
Operator’s Manual
37
Menu No. Technician Level Default Units Notes
5.01 Sequence 1400
5.39 Slow Arm PWM *33 %PWM Sets Wrapping Slow Speed
5.4 Fast Arm PWM *49 %PWM Sets Wrapping Max. Speed
5.41 Rev Arm PWM *30 %PWM Sets Reverse Speed
5.51 1-D Fast Speed *49 %PWM Sets Speed with 1 Plastic
5.15 Slow Start Time *2 Seconds Slow Time Duration at Start
5.16 C&S Open Time 0.3 Seconds Cutter Opening Time
5.17 C&S Close time 1 0.3 Seconds Cutter Closing Time During Wrapping
5.18 C&S Close time 2 2.0 Seconds Cutter Closing Time at End of Wrapping
5.53 1-D Rolls Stop 1.0 Seconds Table Rollers Intermittent Stop Time for 1 Film Wrapping
5.58 1-D Rolls Rot. 1.3 Seconds Table Rollers Intermittent Rotation Time for 1 Film Wrapping
5.48 Tip Return Delay *0 Seconds Delay from Tip to Tip Return
5.5 Load Arm Down 3.0 Seconds Load Arm Down Time
5.49 Tip Return Time *2 Seconds Tip Return Time
5.57 Door Open 5.0 Seconds Minimum Time Accepted for Bailer Door Opening.
5.25 RPM Alarm *35 Seconds Maximum Wrapping Arm Speed
5.28 Set Default Sets Controller Back to its’ Default Settings
1400 Programmable Factors - Technician Level (Pin 1,2,3,4)
Operator Setup Menu
The default settings for the machine are developed by Tanco for optimal operation of the machine.
However, the operator can change certain parameters in the ‘Operator Setup’ menu to take account of
operational conditions.
7. Controller Information