Tanco 1400 Autowrap, Operator'S Handbook Manual, Page: 30 / 132

Tanco Autowrap - 1400
Operator’s Manual
29
Operation
Operation in Automatic mode
The automatic sequence is made up of three sections: Loading, Wrapping and Off-loading.
The controller comes initially set so one press of a button automatically loads the bale, a second press
runs the complete wrapping cycle and a third press automatically off-loads the bale.
It is possible to set the controller so one button press runs the complete cycle, see ‘Changing Default
Automatic Sequence’.
As initially set three buttons on the controller are used to start each section of the sequence, see points,
3, 5, and 7 below.
1. ‘A’ on the display indicates that the controller is set in Automatic mode. If not press (L6) to select.
2. The automatic starts with the wrap arm in the park position, that is with the wrap arm magnet parked
under the sensor, the load arm down and squeeze arm in the fully open position.
3. Press (L5) to start the Auto Load sequence as follows:
- The squeeze arm comes in for a set time, bringing it in under the bale.
- The load arm raises for a set time, lifting the bale on to the table.
- The squeeze arm opens fully to a sensor.
4. If the wrapping arm is not parked in the Park Position then the controller will give an error message
‘DISPENSER POSN’ and it will not start loading. Correct the arm position and repeat.
7. Controller Information