Operator Manual
3–20
Print on CR
This parameter is intended for use by customers whose applications embolden
characters by using a CR-only method to selectively reprint all or parts of a line.
Off:
Ignore bolding, print as regular text (Default setting)
Double Strike: Print line, then backup to reprint (bold by overstriking)
Bold:
Print line once, bold portions printed with enhanced
"bold" style
For example, the application may embolden the word "bold" in the following
sentence by sending:
This is bold<CR>
bold<CR><LF>
"Double Strike" corresponds to the previous POCR=ON setting. With "Double
Strike" selected, bolding is accomplished by re-striking the characters at the
same dot positions. This requires a 1-line backup after printing each <CR>
pass; some applications use many passes to print a single bolded line, so
printing throughput may be reduced accordingly.
With "Bold" selected, bolding is accomplished by rendering the bolded charac-
ters twice, one with a small offset to create a "shadow" effect. The resulting
print is thicker and thus appears darker. This is the same technique used with
the "bold" character attribute selected via emulation escape sequences.
Form Feed at TOF
This parameter dictates how the printer will respond to a Form Feed Control
Code received from the host computer when it is already at a top-of-form
location. If set to Disabled, the printer ignores the Form Feed Control Code
sent from the host. If set to Enabled (default selection) the printer performs the
requested form feed and advances to the next top-of-form.
ESC
This parameter is valid only in the MT660 and LG01 emulations. When set to
Disabled, the ESC control character is ignored. The default is Enabled.
Alt ESC (Alternate Escape)
This parameter is only valid in the MT660 and LG01 emulations. When set to
Enabled, a "^" (carat) character in column 1 (left margin) followed by a CR or a
CR LF can be used in place of the ESC control code. The default is Disabled.
ESC (see above) must also be Enabled for this to work.
Upper Only
This parameter allows you to set up your printer to print in uppercase charac-
ters only from the active Character Set. When this parameter is enabled, the
lowercase characters in Hex positions 61 through 7A are overwritten by the
uppercase characters in positions 41 through 5A. The default selection is
Disabled.
Summary of Contents for T6200 Series
Page 10: ...Operator Manual TOC 8 Blank Page ...
Page 28: ...Operator Manual 1 16 Blank Page ...
Page 36: ...Operator Manual 2 8 Blank Page ...
