TallyGenicom T6200 Series, Operator'S Manual

Page: 23 / 92

1–11
Chapter 1: Setting Up Your Printer
Step 1.
Make sure the printer is Offline or power is off. Open the printer lid and
open the platen gap using the lever, then remove the old ribbon by
lifting it straight up off of the Ribbon Platform.
Step 2.
Remove slack in the new ribbon by turning the knob on the ribbon
cartridge counter-clockwise, then slip the ribbon over the two ribbon
guides and between the front and rear panels of the ribbon shield on
the printer.
Figure 1–12. Removing Ribbon Slack
Step 3.
Press down lightly on the cartridge while turning the ribbon knob
counter-clockwise until it seats on the cartridge drive posts. Make sure
that the ribbon does not twist or fold over.
Figure 1-13. Installing the Ribbon Cartridge
Step 4.
Close the Platen Gap lever.
Installing the Ribbon Cartridge
Ribbon Control Knob