TallyGenicom T6200 Series, Operator'S Manual

Page: 26 / 92

Operator Manual
1–14
CAREFUL!
The left end of the scale (5 & 10 CPI) on the ribbon platform marks the
position of Column 1. Before printing, make sure that this marker is
aligned with the desired position on the form. To align the paper on the
column marker, unlock the tractor and slide it to the desired position,
then lock it in place.
Figure 1–16. Column Alignment Scale
Step 5.
Unlock the right tractor and move it so that the paper holes align directly
over the tractor pins, then close the tractor door. Gently push the tractor
to the right until the paper is smooth and reasonably taut, then lock the
tractor.
Step 6.
Unlock the lower tractors, place the paper over the tractor pins, then
adjust the tractors so that the pins line up with the paper holes. Lock the
tractors.
Step 7.
Adjust the platen gap, the use the Paper Tension Lever to adjust the
tension on the form between the upper and lower tractors. Don't forget
to reset the top-of-form (TOF) before procedding with printing (see
Chapter 2).