TallyGenicom 2248, User Manual

Page: 59 / 240

User's Manual
PAPER HANDLING
3-13
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
NOTE
When you use continuous forms, make sure that the edges of both left
and right paper guides do not touch the paper.
Slide both paper guides flush against the ends of both sides.
Adjusting the TEAR OFF position
When the TEAR OFF button is used to advance the paper to cut it, the paper
cut position and the perforation position may not match. In such cases, adjust
their positions by using the following procedure.
Adjustment procedure
:
1. Use the TEAR OFF button to advance the paper to its cut position.
(Keep holding down the TEAR OFF button.)
2. While holding down the TEAR OFF button, adjust the cut position by
using the LF/FF button or LOAD button.
- LF/FF button: Pressing this button once extends the paper feed
amount by 1/180 inches.
- LOAD button: Pressing this button once reduces the paper feed
amount by 1/180 inches.
- The adjustment range is plus or minus 63/180 inches (ap-
proximately 9 mm). When it is exceeded, an alarm beeps.
3. When the cut position is adjusted, release the TEAR OFF button.
The paper feed amount at the end of the adjustment is stored as the
amount by which the paper will be fed when the TEAR OFF button is
pressed.