TallyGenicom 2248, User Manual

Page: 119 / 240

Setup Mode
USING SETUP MODE
User's Manual 5-45
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options Description
<CONT-PE> Detection of end of continuous forms.
TRACTOR Paper end is detected by the sensor on
the tractor unit.
Paper-end unprinted area:
Continuous forms: About 80 mm
EDGE Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4.7 mm for both continu-
ous forms
GATHER
Setting of ribbon protective control
at a line feed on continuous forms
ENABLE The protective control is executed.
DISABLE The protective control is not
executed.
CUT-CTL Setting of retracting control at
canceling TEAR OFF of continuous
forms.
PRCISIN The precision-prioritized retracting
control is executed.
It retracts a certain amount of paper
(the top part of the paper which
hangs out from the TOFS), and then
moves back to the position before
TEAR OFF. If TOFS detects paper
end when a certain amount of paper
is retracted, it executes the continu-
ous forms save operation and then
executes the paper loading opera-
tion.
SPEED The speed-prioritized retracting
control is executed.
It retracts the paper by the amount
the paper was advanced.