TallyGenicom 2248, User Manual

Page: 51 / 240

User's Manual
PAPER HANDLING
3-5
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
USING SINGLE SHEETS
This section describes how to load paper in the cut sheet stand or cut sheet
feeder.
The cut sheet stand allows paper to be loaded manually, one sheet at a time.
A cut sheet feeder allows paper to be loaded automatically from a stack.
Loading a Single Sheet of Paper
To load a sheet of paper into the cut sheet stand:
1. Make sure that the printer is turned on. Check that rear-fed continu-
ous forms are retracted to the park position. (For details, see the
section Unloading Continuous Forms later in this chapter.)
Table 3.2 Paper Thickness Lever Settings
Number of Copies
(Including the Original) *1
1 copy 1
2 copies 2
3 copies 3
4 copies 4
5 copies 5
Ribbon replacement D
*1 For carbon-interleaved paper, the carbon counts as one copy.
*2 Vary the setting up or down (including A to D ) to optimize printing.
Select D when replacing a ribbon or clearing a paper jam. For labels
and envelopes, use trial-and-error to determine a satisfactory setting.
NOTE
If printing is messy, the ribbon misfeeds, or the paper jams, move
the lever one setting higher.
S e t t i n g
* 2