![background image](http://html2.mh-extra.com/html/takeuchi/tb23r/tb23r_operators-manual_3344682033.webp)
31
SAFETY
Maintenance Precautions
level. Doing so could cause the fluid to
leak, contact and damage the skin, or
cause parts to corrode.
Have a Takeuchi service agent
repair welding
Have a Takeuchi service agent repair
welding
If welding must be performed, make sure
that it is done by a qualified person in a
properly equipped workplace. To prevent
any part from breaking down or being
damaged due to overcurrent or sparks,
observe the following.
�
Disconnect the wiring from the battery
before doing electric welding.
�
Do not continuously apply 200 V or
more.
�
The earth ground must be connected
within one meter from the welding
section. Do not connect the earth ground
near to an electronically controlled
device/instrument or connectors.
�
Make sure that there are no seals or
bearings between the welding section
and the earth ground.
�
Do not connect the earth ground around
the pins for the working equipment or
hydraulic cylinders.
�
When welding is to be done on the
machine body, disconnect the connectors
for the electronically controlled devices
before working.
Checks after maintenance
�
Gradually raise the engine speed from a
low idle to maximum speed and check
that no oil or water is leaking from
serviced parts.
�
Move the controls and check that the
machine is operating properly.
Disposing of wastes
�
Funnel spent fluids from the machine into
containers. Disposing of fluids improperly
destroys the environment.
�
Follow the prescribed regulations when
disposing of oil, fuel, engine coolant,
refrigerant, solvents, filters, batteries or
other harmful substances.
Vibrations to which the operator is
subjected
According to the results of the tests carried
out to determine the vibrations transmitted
to the operator by the machine, the upper
limbs are subjected to vibrations lower than
2.5 m (8.2 ft) / sq.sec. while the seated part
of the body is subjected to vibrations lower
than 0.5 m (1.64ft) / sq.sec.
Handling of poisonous chemicals
Poisonous chemicals will cause serious
injury if directly contacted.
Poisonous chemistry used in this machine
includes grease, battery solution, coolant,
paint and adhesive agent.
Summary of Contents for TB23R
