Takeuchi TB23R, Operator'S Manual

Page: 59 / 190

57
CONTROLS
Accessories
(15) DISP (Time / Frequency) button
This system is equipped with a clock which
can show the accurate time. Even if the
radio is off, the clock still shows the time.
(16) PS / AS switch
Pushing this button for 2 seconds down
will automatically operates to show the
memorized station from 1 to 6. The signal
scanning start by pushing this button
momentarily. When a station is received
the scanning automatically stops there for
5 seconds FLASHILY and then resumes
scanning. As soon as the desired station is
found, press the this button again.
If you will auto memory push this button
over 5 sec so initiates a scan of the band.
Station frequencies are either stored in order
of low of frequency for FM, or in sequence
for AM, starting from preset channel 1. If all
of the preset channels have not been filled
up after one scan, the remaining preset
channels are left unchanged, and channel 1
is recalled. Channel 8 flashes during A.
�
Set the time
After pressing DISP button, press tuner
button
or to correct the time. Press
tuner button to set the “hour” and tuner
button for setting the “minute”. Set the
time when the time is shown.
External Power Sockets (for EU)
WARNING
Only use applicable electric products
with these sockets.
for Beacon
Use these sockets as an external power
supply. When using these sockets, be
careful not to exceed 12V/10A.
To use, raise the cap (1).
C4C023
D5B032
1
Hour Minute