TAKASAGO ZX-S-1600LAN, Instruction Manual

Page: 128 / 204

Using in Series/Parallel Operation
------------------------------------------------------------------------------------
125
SERIAL I/F 1
SERIAL I/F 2
TERMINATION
LINE INPUT
OFF
ON
IN OUT
M/S CONTROL
SENSE
+
DC OUTPUT
-
+ -
SERIAL I/F 1
SERIAL I/F 2
TERMINATION
OFF
ON
IN OUT
M/S CONTROL
SENSE
+
DC OUTPUT
-
+ -
100-240～,50/60Hｚ,7A MAX
LINE INPUT
負 荷
－ +
２．Error Displays for Slave Units
In the event an alarm is triggered by a Slave while the Master is functioning normally;
①The Slave that detected the alarm will display the error code (top) and alarm type (bottom) in the Number Display.
②Error code “E006” is displayed on the top Number Display of the Master unit.
(When alarm is triggered by a Slave and Master is functioning normally)
Series Operation
A series connection of two ZX power supply outputs can be used to double the output voltage. Further, Master-
Slave Series Operation, the controlling of the output with a single Master, is available.
Connecting
Connect as shown in the below diagram.
◆Load Wire Connection
① Connect wires from the Slave’s minus terminal to the Master’s plus terminal.
② Connect wires from the Slave’s plus terminal to the Load’s plus terminal.
③ Connect wires from the Master’s minus terminal to the Load’s minus terminal.
◆Control Terminal Wiring
① Connect wires from the Slave’s external control connector No. 22 terminal to the Master’s plus terminal.
② Connect wires from the Series control connector to the Master’s minus terminal.
●
An LA type is necessary for the Slave unit. (Both the LN and LAN types can be used for the Master Unit.).
●
Series operation is only possible with models that have the same number indicated in the xxx part of ZX-S-xxx.
●
Connecting different device models will result in breakdown.
●
Turn all series connected ZX-S Series input power (POWER switch) ON.
●
Please calibrate the output voltage for the Slave before use.
●
FUNCTION Settings items, when operating in Slave, are restricted.
●
When operating in Slave, the only valid keys during an alarm reset are the OVP + OCP (pushed simultaneously),
"OCP", "FUNC.", and "LOCAL" keys.
●
The indication on the front display during series operation shows the outputs of the Master unit and the Slave
unit respectively. (When the output voltage is 160V, both the Master unit and the Slave unit will be 80.00V.
Caution

（Master Unit） （Slave Unit）
IN OUT
1
13
26 14
外部コントロール用
コネクタ（付属）
直列コントロール用
コネクタ
Load
Series Control
Connector
External Control
Connector (Accessory)