Takara Belmont YUME SWING, Installation Manual, Page: 17 / 36

２ Marking the bolt anchor points.
(1) Check the mirror and cabinet center line.
○ Refer to the floor template (pages 5 to 6) and overall
layout diagram, check the dimension of the raised
pipes of water, hot water and drain, and prepare
for the installation.
(1) Set the paper template on the floor aligning it with
the floor fixing position of the fixing base.
*The floor fixing point of the fixing base differs
depending on the chair used with Yume Swing.
(2) Mark the screw or bolt anchor position of the
fixing base of SWING arm (five locations).
(3) Drill holes at the screw or bolt anchor
position on the marked points of the floor.
(4) Remove the paper template.
*Without detaching the rotation arm cover, fixing base
can not be fixed on the floor.
*The screws of rotation arm cover (screw with gasket
(M5 x 12) x 5 pcs.) will be used when attaching it again,
so please pay attention not to lose them.
１ Detach the rotation arm cover of SWING arm.
＜ Front Layout ＞
＜ Rear Layout ＞
Check the Position of Mirror and Cabinet
１
Installation of SWING Arm
２
Wooden floor Other than wooden floor
Screw (M8 x 65) Anchor bolt (M8 x 70)
[Unit: mm]
【 Bolts to be used 】
Paper template
Drain pipe
Water
supply
pipe
Hot water
supply pipe
Drill
Drill holes.
Fixing base
Rotation arm
Screws (M5 x 12)
(with gasket)
Rotation arm cover
Detach
Please note that this is a template for the standard
slide layout and not for the reverse slide layout.
However, you can use this as a template for the
reverse slide layout by turning it over.
Caution
Cabinet
Wall
Mirror
Center
Mirror
Wall
Center
17