21
●
Installation process of anchor bearings (Other than wooden floor)
(8) Drill the hole at the rest of 6 locations.
(9) Remove the taping (2 pcs.) from and
attached previously and remove the caster rail.
(10) Hammer the anchor bearing in the rest of 6 holes.
(2) Place the caster rail and drill hole on the part .
(3) Remove the caster rail and hammer the anchor
bearing on the hole.
(4) Return the caster rail to the initial position and fix the
part using with tapping (5 x 30).
Other than wooden floor
Tapping (5 x 30)
Anchor bearing
Unit: mm
【
Screws to be used
】
２
Hammer anchor bearing in the caster rail attachment positions.
(1) Insert the caster rail under the rotation arm and set
it aligning with the paper templates.
*Hairline surface to be placed upward.
Hairline surface of caster rail to be placed upward.
■
Other than wooden floor
(5) Drill a hole on part .
(6) Loosen the tapping of , move the caster rail
slightly and hammer the anchor bearing.
(7) Return the caster rail to the initial position and fix
and using with tapping (5 x 30).
Caution
(1) Drill open a hole of the
specified diameter and
depth.
Floor
6mm
Depth of hole
around
40mm
(2) Remove the dust from
each hole by cleaning
with a vacuum cleaner,
etc.
→
(4)Align with caster rail
attachment holes and
fasten the tapping.
(3) Insert the anchor bearing
and tap it with a hammer
completely.
Anchor Bearing
Anchor
bearing
tapping
Caster rail
A
Drill the hole on the part A.
Drill the hole on the part
B (A is fixed.).
Drill hole on the rest of
the attachment holes.
(A and B are fixed.)
A
B
A
A
B
A
B
Paper template
A
A
B
B
A
Upper surface : Hairline finish
(Surface containing the line in the same direction)
Under surface
(Surface without line)
Summary of Contents for YUME SWING
Page 35: ...35 MEMO...
