Tait TM9456, Installation And Programming Manual

Page: 17 / 53

TM9456 Dual-Radio Installation and Programming Guide Preparing the Installation 17
© Tait Limited July 2016
Notice The dual body solution will only operate as a system. The cor-
rect radio body interface must be connected to the corresponding radio,
and both radios and body remote interfaces must be connected before
the system will operate.
1.6 Removing and Installing Grommets
Grommets ensure that the radio system and all connections are sealed
against water, dust and other environmental hazards. A dual-radio system
requires a grommet in the unused remote-interface port (item
g in
Figure 1.2 on page 17 ). A dual-radio system also requires all cable
grommets to be installed.
Removing a
grommet
1. Using your thumb or forefinger, lift up one of the corners of the
microphone grommet. Firmly (but gently) pull that corner until the
seal comes away from the cavity. See
Figure 1.2 .
Figure 1.2 Removing a grommet
2. Repeat to expose another corner.
3. Pull the exposed corners back and remove the grommet.
4. If removing a cable grommet, slide the grommet along the cable to
reveal the plug.
Installing grommets
1. If installing a cable grommet, slide the grommet along the cable.
2. Push two adjacent corners of the grommet into the socket cavity.
3. Squeeze the grommet and push the remaining corners into position.
4. Check that the grommet is seated correctly in the cavity. See
Figure 1.3 .
Figure 1.3 Correct seating when installing a grommet
grommet