TM9456 Dual-Radio Installation and Programming Guide
Installing a Dual-Radio System
33
© Tait Limited
July 2016
Mounting the
Control Head
The remote U-bracket is used to install the remote control-head assembly
on the dashboard or on any sufficiently flat surface.
Notice
Check that the remote U-bracket is not distorted when the
screws are tightened.
1.
If precise positioning is required, predrill
3mm (1/8 inch) pilot
holes for the selfdrilling screws. Reduce the hole size in metal that is
less than 1mm (1/32inch) thick.
2.
Screw the remote U-bracket in the chosen mounting position using
the self-drilling screws provided. Use all four screws provided.
3.
Place the control-head assembly in the remote U-bracket and
position it for a good viewing angle.
4.
Screw the remote control-head assembly into position using the two
thumb screws provided.
Notice
When fitting the control-head interface to the control-head, be
careful not to damage the space-frame seal.
