TM9456 Dual-Radio Installation and Programming Guide
Installing a Dual-Radio System
23
© Tait Limited
July 2016
2.
Plug the body-
interface loom
onto the control-
head connector.
3.
Insert the bottom
edge of the
control head onto
the two clips in
the front of the
radio chassis,
then snap into
place.
2.4.3
Mounting the Radio Bodies
Mount the two radio bodies less than 0.5 metres (1.6 ft.) apart using the
preferred mounting method (such as U-brackets, slide-in cradles, a stack
mount, or security brackets).
The 219-03736-00 cable and mounting screws must be used to provide the
required grounding between the two radio bodies. The cable is attached to
each radio body by either a bottom mounting boss, or a side mounting boss
(whichever is more convenient). An example is shown in
.
Figure 2.4
Example of a Ground Strap Wiring on a Stack Mount
