Tait TM9456, Installation And Programming Manual

Page: 24 / 53

TM9456 Dual-Radio Installation and Programming Guide Installing a Dual-Radio System 24
© Tait Limited July 2016
For more information, refer to the instructions included with the cradle or
bracket installation kit.
2.4.4 Installing the Radio Connecting Cable
Figure 2.5 contains an overview of the connections between both radio
bodies and the control head. For information on the pins and signals of all
ports, see
“Pins and Signals” on page 25 .
Detailed Steps
1. Remove all appropriate
grommets. See
“Removing and
Installing Grommets”
on page 17
.
The outermost port of
the radio body with
link J4 fitted is not
used. Leave the grom-
met installed in this
port (item
g
in Figure 1.2 on page 17 ).
Notice
If a radio body does not have link J4 removed, or you cannot
identify the correct radio body to use, you will need to disassemble one
or both interfaces. See
“Removing the Body Interface” on page 22 for
more information.
2. Attach one end of the radio connecting cable to the outermost port of
the radio body with link J4 removed.
The innermost port of this radio connects to the control head solution.
3. Attach the other end of the radio connecting cable to the innermost
port of the other radio body.
4. Install the cable grommets. See “Removing and Installing
Grommets” on page 17 .
Figure 2.5 Overview of connections between radio bodies and control
head
outermost
port
body with link J4 fitted
body with link J4 removed
innermost
port
radio connecting cable
T02-00009-0101 (0.6 m / 1.9 ft.)
to control head
solution
outermost
port
innermost
port