Tait TM8100 mobiles, Service Manual

Page: 151 / 620

TM8100/TM8200 Service Manual Disassembly and Reassembly 151
© Tait Electronics Limited November 2007
7. While pulling upwards on the space frame
G
at the corner where the
microphone connector is situated, release the clips labelled
B
to
G
in
Figure 5.11 in the order:
B
and
C
,
D
and
E
, and then
F
and
G
.
To release each clip use a 3/16 inch (5mm) flat-bladed screwdriver to
lever the clip out of its recess. Pulling on the space frame helps release
the clips.
Important
When fitting the space frame
G
, make sure that the clips
labelled
B
to
G
fully snap into the front panel assembly.
If necessary, use a flat-bladed screwdriver to push down the
clips until they snap into place.
Figure 5.11 Components of the control head (1-, 2- or 3-digit display)
B
control-head loom with female-female
adapter
C control-head options board (optional)
D
3 x 8 PT screw (x3)
E control-head board
F elastomeric strip (x2)
G space frame
H speaker clamp
I speaker
J short light pipe
1) long light pipe
1! keypad
1@
LCD
1# concealed microphone (optional)
1$ front panel assembly
1% knob for volume-control potentiometer
x3
B
C
E
F
x2
1#
i
j
1)
1@
h
g
1!
1$
1%
d
Torx T10
5lb·in (0.6N·m)
B
G
E
C
d
F