Tait TM8100 mobiles, Service Manual

Page: 527 / 620

TM8100/TM8200 Service Manual TMAA03-02 Security Bracket 527
© Tait Electronics Limited November 2007
4. If the slide locks are closed, open them by inserting the slide lock key
into the keyhole. Rotate the key 90° (it will slip into a detent),
and pull.
Two slide lock keys are supplied so that you can either use them both
at once, or so that you can keep one as a spare.
5. Place the radio over the security bracket base so that the feet of the
mounting rails fit securely into the base.
6. Close the slide locks by pressing them into the base. You should hear
an audible click as the internal spring lock mechanism engages.
Warning!!
For continued safe operation, replace and do
not re-use Security Bracket once it has been
involved in a crash greater than 50km/h.
24.3 Removing a Radio from the Security Bracket
Remove the radio from the security bracket as follows:
1. Open the slide locks by inserting the slide lock key into the keyhole.
Rotate the key 90° (it will slip into a detent), and pull. The pull will
be need to be quite firm to open each slide lock.
2. Remove the radio and its mounting rails by lifting it up and out of
the security bracket base.
3. If required, remove the mounting rails from the radio body base by
unscrewing them.
24.4 Replacing the Radio in the Security Bracket
To replace the radio in a security bracket, first follow the steps in
“Removing a Radio from the Security Bracket” on page 527, and then
follow from step 2 in “Installing the Security Bracket and Radio” on
page 526.
24.5 Disassembling the Security Bracket
Disassemble the security bracket as follows:
1. Remove the radio from the security bracket by following the steps in
“Removing a Radio from the Security Bracket” on page 527.
2. Unscrew the four self-tapping screws holding the security bracket
base in place.