Tait TM8100 mobiles, Service Manual

Page: 17 / 620

TM8100/TM8200 Service Manual Introduction 17
© Tait Electronics Limited November 2007
1.4 Product Codes
This section describes the product codes used to identify products of the
TM8100 and TM8200 mobile radio product lines.
General
The product codes of the TM8100 and TM8200 mobile radio product lines
have the format:
TMA abc – ddee
where:
■
a identifies the product category:
A=accessory, B=radio body, C=control head, S=software feature
■
b , c , dd and ee identify specific product features.
Radio Bodies
The product codes of the radio bodies have the format:
TMAB bc – ddee[f]
where:
■
b identifies the architecture of the digital board:
1=conventional analog
2=conventional analog (dual-mode capability)
3 identifies the digital boards of the digital TM9100 product line.
■
c identifies the RF output power:
2=25W, 3=25W (trigger-base), 4=30 to 59W,
5=30 to 59W (trigger-base).
■
dd
identifies the frequency band:
A4=66 to 88MHz, B1=136 to 174MHz, C0=174 to 225MHz,
D1=216 to 266MHz, G2 =350 to 400MHz, H5=400 to 470MHz,
H6=450 to 530MHz, H7=450 to 520MHz, K5=762 to 870MHz
(Tx), 762 to 776MHz and 850 to 870MHz (Rx).
■
ee identifies any radio options:
00=BNC RF connector, 01=mini-UHF RF connector
■
[f] (optional) identifies a combination of software features as loaded at
the time of manufacture
Control Heads
The product code of the control heads has the format:
TMAC bc – dd[ee]
where:
■
bc identifies control-head user interface and hardware options
■
dd identifies badging and configuration variants
■
[ee] (optional) identifies variations from the standard firmware and or
data load at the time of manufacture.