Tait TM8100 mobiles, Service Manual

Page: 534 / 620

534 Installing a Remote Kit TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
25.1.8 Connecting the Remote Cable
Caution
When drilling holes in the vehicle, check that drilling
at the selected points will not damage existing wiring,
petrol tanks, fuel lines, brake pipes or battery cables.
1. Drill any holes required for cables and install suitable grommets or
bushings in the holes.
2. Plug one end of the remote cable into the control-head interface.
3. Run the remote cable to the torso interface and plug it into the
RJ45 connector without a bung.
Installing the
Remote-Cable
Grommets
Install both the remote cable grommets, using the following procedure.
Important
The remote cable grommets must be installed whenever the
remote cable is plugged into the RJ45 sockets. When
installed, the grommets have two functions:
■
to prevent damage to the RJ45 sockets when there is
movement of the remote cable, and
■
to ensure that the radio and remote control-head assembly
is sealed against water, dust and other environmental
hazards.
1. Slide the grommet along the remote cable and push two adjacent
corners of the grommet into the RJ45 socket cavity.
2. Squeeze the grommet and push the remaining corners into position.
3. Check that the grommet is seated correctly in the cavity.
Figure 25.2 Correct remote cable grommet seating
microphone
grommet
control head