Tait TM8100 mobiles, Service Manual

Page: 420 / 620

420 CODEC and Audio Fault Finding TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
13.6 Faulty Modulation Using Auxiliary Connector
Introduction
This section covers the case where the transmitter operates normally but
there is no modulation (although there is modulation at the auxiliary
connector). There are two tasks:
■
Task 15 : apply
AUD TAP IN
signal
■
Task 16 : check CODEC 2 device
If there was also a fault with the speaker audio at the auxiliary connector, it
is assumed that this has now been rectified.
Task 15 —
Apply
AUD TAP IN
Signal
First check the modulation and, if necessary, the DC offset.
1. Enter the CCTM command
33
to place the radio in transmit mode.
(The frequency is that of channel 1.)
2. Check the modulation via the microphone input.
3. Enter the CCTM command
32
to place the radio in receive mode.
4. If the modulation is correct, go to Step 5 . If it is not, go to Task 12
of “Faulty Modulation” on page 416 .
5. Apply a 1kHz AC-coupled signal of 0.7V
pp
at pin 7 (
AUD TAP IN
) of
the auxiliary connector (alternatively, as
ITF AUD TAP IN
at the junction
of R237 and R241 — see Figure 13.10 ).
6. Enter the CCTM command
323 t5
.
7. Check the DC offset voltage at pin 7:
8. If the above DC offset is correct, go to Step 9 . If it is not, go to
Step 11 .
9. Remove the
CDC TOP
can.
10. Check for and repair any soldering faults around IC205 , or else
replace IC205 (see Figure 13.10 ). Conclude with Step 12 .
11. Check for shorts at pin 7 of the auxiliary connector. If there are none,
go to
Task 16 . If there are, repair the fault and conclude with Step 12 .
12. Confirm the removal of the fault and go to “Final Tasks” on
page 163 . If the repair failed, replace the board and go to “Final
Tasks” on page 163 .
pin 7 of auxiliary connector: approximately 1.5V DC offset