Tait TM8100 mobiles, Service Manual

Page: 546 / 620

546 Installing an Enhanced Remote Kit TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
26.1.1 Overview
Installing the control head remotely is done in six steps:
1. Remove the control head from the radio body, if necessary.
2. Install the torso interface
b
onto the radio body.
3. Mount the remote U-bracket
d
in the required position.
4. Install the control-head interface
c
onto the control head and install
the remote control-head assembly in the remote U-bracket.
5. Mount the U-bracket in the required position and install the radio
body in the U-bracket.
6. Route the remote cable
e
between the remote control-head
assembly and the radio body.
26.1.2 Parts Required
The following diagram identifies the parts for remote control-
head installation and shows how they fit together.
Figure 26.1 Parts for remote control-head installation
b torso interface h RJ45 bung
c control-head interface i control-head interface loom
d remote U-bracket j torso-interface loom
e remote cable 1) earthing tag
f self-drilling screw 1! earthing-tag screw
g thumb screw 1@ remote cable grommets
c
b
f
g
d
e
h
i
1)
j
1!
1@