Baofeng UV-B5 Step-by-Step Programming Guide
Also applies to UV-B6
Noji Ratzlaff
Set the radio to communicate with a repeater at 147.080+ MHz, 77.0 Hz
0.
Turn on the radio and make sure it’s unlocked
1.
VM /SCAN (frequency mode)
2.
Select the upper display
AB
5
3.
Set the frequency
1 - 4 - 7 - 0 - 8 - 0
4.
Turn off the TDR
M ENU -
(10) - AB
5
- OFF - AB
5
- M ENU
5.
Set the repeater offset
M ENU -
(22) - AB
5
- 00600 - AB
5
- M ENU
6.
Set the repeater shift direction
M ENU -
(21) - AB
5
- + - AB
5
- M ENU
7.
Set the transm it tone frequency
M ENU -
(12) - AB
5
- M ENU -
(77.0) - AB
5
- M ENU
8.
Set the transm it pow er level
M ENU -
(04) - AB
5
- HIGH - AB
5
- M ENU
Your radio is now set to transm it as specified
Store the current repeater and tone settings in a memory channel
0.
Follow the procedure above to set your radio
for the frequency of your choice
1.
Store the frequency in channel 57
Press and hold VM /SCAN
(57) - AB
5
(Note: if the channel num ber is blinking, there
is already a frequency stored there, and this
w ill overw rite it)
The frequency is now stored in radio mem ory
Recall a stored memory setting
1.
Press VFO/M R (channel mode)
2.
Press the up or dow n arrow s or enter the
tw o-digit channel num ber (both digits)
0 - 6
The stored channel is now ready for use
