Taiden HCS-4100/50 Series, Installation And Operating Manual

Page: 85 / 223

72
C. “LogOut” (key “4”)
It is used under IC-Card sign-in mode or/and PIN code
sign-in mode.
It is used for locking the units in case the delegates
leave for a short time. Delegate units will work on after
delegates sign-in again (The DCS server cannot stop
sign-in).
D. “Other” (key “5”)
Use this key to request intercom, setup LCD display
language and system information:
“Call” (key “1”)
The earphone shall be plugged to use the intercom
function. If not, it will remind you to plug the earphone.
If the current unit is using the intercom function, it will
remind you that the line is busy. Press “Call” (key “1”) to
use the intercom function, and the following interface at
the left side is displayed. When the operator approved
your request, then the following interface at the right
side is shown:
“ Setting ” (key “3”)
Press “Setting” (key “3”), and the following interface is
shown:
ƒ Press “ Language ” (key “1”) to select the LCD
display language between several languages. The
range is limited by the configuration in the CMU
(refer to section 2.4);
ƒ Press “ Info ” (key “3”), and the following interface is
shown:
x
Press “ Interpretation ” (key “1”) to run through
information about all interpretation languages:
x Press “ Right ” (key “3”) to check the rights of this
unit:
x
Press “ About ” (key “4”) to display the product
information:
8. VIP unit
ƒ Any delegate unit can be assigned as a VIP unit by
the HCS-4100/50 application software. At most 32
VIP units can be assigned;
ƒ As long as the active microphone number does not
exceed 6 (including chairman/delegate/VIP), the
microphone of the VIP unit can be activated freely;
ƒ If the priority mode is configured as “All off”, all
active delegate microphones will be turned off
when the chairman presses his priority key, and all
active VIP microphones will be muted temporarily.
They will restore when the chairman releases his
priority key;
ƒ
If the active microphone number reached 6, the
microphone cannot be turned on unless one of the
active microphones is deactivated.