The low-impedance (100
Ω
) output is buffered and will drive long
cables or several inputs in parallel if required. Use a good-
quality, screened analog phono-phono audio cable (such as our
Cable AvantGarde F3-10-ANA) to connect the phono sockets
marked
AUDIO OUTPUT left
and
right
on the rear of your T32R to
the corresponding tuner inputs of your preamplifier
(1)
.
The digital outputs are provided to allow connection of your T32R
to equipment with a suitable digital input (such as a MiniDisc
recorder or our av processor AV32R). These outputs are only
active when the T32R is tuned to DAB transmissions.
The digital output is routed to the phono, BNC and optical
sockets on the rear panel of the T32R marked
1
,
2
and
3
respectively. These outputs are grouped together under the
digital output
heading found in the
DAB MODULE (OPTION)
on
the rear panel. The electrical digital outputs conform to the SPDIF
format and are intended to be used with 75
Ω
cable
(2)
. The
optical digital output conforms to the EIAJ RC-5720 format
and is intended to be used with an optical cable.
audio outputs
digital outputs
(D
A
B option)
47
outputs
1. If your preamplifier does not have an input labelled tuner, you can usually
connect to an input labelled ‘aux’ or ‘line’ instead
2. Use a good-quality, screened digital interconnect (such as our Cable
AvantGarde F3-10-DIG)
A U D I O
O U T P U T
left
right
digital output
2
1
3
spdif 75 ohm
eiaj
*LASER*-T32R Manual v3.7x 8/29/02 12:14 PM Page 47
