T-VIPS CP560, User Manual

Page: 120 / 200

120 WEB Interface
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
8.6.3 Main
Figure 8.68 Output Configuration.
The Main page lets the user configure port level parameters on the selected Output.
The page is shown in figure 8.68 for manual bitrate config mode.
The Main Configuration section lets the user configure the following parameters:
Enable output
Enable or disable the output.
Output label
This lets the user type in a label for the selected output. The label is only used for
presentational purposes.
Bitrate setting
This lets the user to manually enter a bitrate or let it be set automatically by the unit. If
automatic mode is selected the CP560 will always select the minimum bitrate needed for
the T2-MI stream, thus reducing the number of stuffing packets (PID: 8191) to zero.
Set output bitrate
This field sets the desired ASI output bitrate for the selected port.
Current bitrate
This shows the current measured total bitrate being transmitted on this output. This value
may vary slightly from the configured value due to measurement errors.
Effective bitrate
This shows the effective bitrate being transmitted on this output.
Forced stuffing
This parameter is used to guarantee a minimum amount of null packets (PID 8191) in the
output stream, When enabled, the parameter specifies the maximum number of non-null
packets to transmit before inserting a null packet. The bitrate resulting from the configured