T-VIPS CP560, User Manual

Page: 32 / 200

32 Physical Description
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
Table 6.5 ASI Output LED description
LED Colour Description
Lower green Lit when output is enabled, unlit otherwise.
Upper Not in use for outputs
6.1.7 SFP port
The CP560 has one slot for SFP modules.
When using the SFP slot, the DATA-2 Electrical Ethernet data port is turned off. This is done
on the ’Device Info-
>
Maintainance’ page.
To use the SFP slot, the licence key SFP module must be installed.
6.1.8 Power Supply
Section
4.5
provides details of the power supply, protective earth and security. Read all these
instructions, prior to connecting the units power cable.
6.1.9 Ethernet Management Port
The CP560 provides one Ethernet port for control and management. Connect the management
port to the management network. The LEDs for the management port are used as follows:
6.1.10 Technical Earth
Connect the Technical earth to a suitable earth point.
6.1.11 Alarm/Reset
The unit is equipped with a 9-pin male DSub connector to provide alarm information.
Two programmable relays are provided. The first relay is always activated on a critical alarm or
when the unit is not powered. Please refer to section
8.4.2.3 for a description of how to program
the relays.
The pin out of the connector is shown in table 6.7 .
When there is a critical (level 6) alarm in the unit, unit is not powered or any other programmed
condition for relay 1 is satisfied, there will be a connection between pin 6 and pin 7. When the
above conditions are not present, there will be a connection between pin 7 and pin 8.
The optional (additional) relay will follow the same behaviour, except that it can also be pro-
grammed
not to be activated for a critical (level 6) alarm.
A connection between pin 9 and 5 (or a TTL low on pin 9) will hold the unit in reset if this
function has been enabled. The connection must be held for 0.5 seconds in order to active the
reset. This can be used to force a hard reset of the unit from an external control system. This
pin can also be used as a general purpose input (GPI).