T-VIPS CP560, User Manual

Page: 57 / 200

WEB Interface 57
ID: um_t2gateway CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686)
Speed/duplex mode
The speed and duplex mode of the interface. The Auto setting enables automatic speed
and mode negotiation for the Ethernet link. This option is not available for SFP interfaces.
Note: Modifying the default settings of interface duplex to any-
thing other than auto can cause unpredictable results unless all peer
systems accessing the port use similar settings.
For more techni-
cal information regarding auto negotiation and duplex mismatch, refer to the
((http://en.wikipedia.org/wiki/Duplex_mismatch,Wikipedia duplex mismatch arti-
cle))(http://en.wikipedia.org/wiki/Duplex_mismatch).
MAC address
The Ethernet Media Access Control (MAC) address of the management interface.
Detect configuration
Applies to the Control interface, only.
These two boxes enable read and write attributes of the
T-VIPS Detect
IP assignment
server module. This server is a stand-alone PC application that can be used to discover
T-VIPS devices on a local network and assign IP addresses to them.
Enabling the Read option makes the CP560 visible for the T-VIPS Detect on the LAN. If
the Write option is enabled the IP address of the CP560 may be configured using the T-
VIPS Detect. These options do not affect the operation of the device from the management
application
T-VIPS Connect
.
8.4.5.1.2 Alarms
Alarms related to the interface are listed on the Alarms page. Clicking an alarm opens the field
to configure the alarm. Please see Section 8.4.2 for alarm configuration details.
Figure 8.17 Network interface alarms
At the top of the page two radio buttons are provided to select between displaying error count
or error severity. In addition all alarm counters related to this interface may be reset.