T-VIPS CP560, User Manual

Page: 98 / 200

98 WEB Interface
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
minimum rate allowed for a given PID below which an alarm is raised. The default value
is shown to the right.
Alarm turned on
Number of times the alarm has triggered. If the alarm is filtered this counter will not
increase.
Error count
For alarms that are checked continuously, this counter shows the number of times an alarm
condition has been violated. This counter will increase even if the alarm is filtered.
Global setting
This field shows the value configured for this alarm in the global settings. If the alarm
severity level is set to
global default in the “Severity” pull-down list, this is the value that
will be used.
In addition, if the alarm contains a limit, e.g. max interval, a numeric input at the bottom is
displayed. This lets the user override the default limit, which is shown in brackets to the right.
Reset counters
This button lets the user reset the "Alarm turned on" and "Error count" counters for this
alarm.
"PID" and "Service"alarms ( Figure 8.51 ) allow overriding of sub items. For such alarms two
tables are shown below the alarm details.
Figure 8.51 Alarm severity per sub-ID (typically Service or PID)
The Service/PID with active alarms table shows all currently active alarms on sub-items for the
selected alarm. The following columns are found in the table.
Service/PID
The id of the sub-item.