T-VIPS CP560, User Manual

Page: 118 / 200

118 WEB Interface
CP560 DVB-T2 Gateway User’s Manual Rev. 2.2 (3686) ID: um_t2gateway
automatic switch. If not Valid and selected the switch will try to switch to the highest
prioritised input that is Valid.
Return
Whether to automatically return to this port if is valid, even when the currently
selected port is valid. Will only return to higher prioritized sources.
Add port by selecting the port in the drop-down list and pressing Add .
Remove a port by selecting the port in the grid and pressing Remove .
Switch manually to a port by selecting it in the grid and pressing Switch To .
Note: When doing manual switches in Automatic switch mode, the switch
might automatically switch away from the selected input after the Return
Wait time has passed.
8.5.3.2 Alarms
The Alarms sub page allows the user to configure the alarms for the input switch. It works
identically to and is described under Device Alarms in section 8.4.2.1 .
8.6 Outputs
The Outputs page contains all information and settings that apply to the output ports on the
device. The navigation list on the left side lets the user select which output to view, or to select
’Outputs Overview’ to view a summary of all the outputs on the device.
The labelling of the outputs is a combination of the user defined name of the output and the
physical number of the output port.
8.6.1 Outputs Overview
Figure 8.66 Outputs Overview
The Outputs Overview page shows a short summary of all the logical TS outputs on the device.
The table has the following columns:
Enable
This shows whether the output is enabled or not. The output enabled or disabled for an
output by clicking this check box and hitting apply.