English
I/O Board address:11
Setting..........:32
Display address
Setting..........:00
Display address
to continue
Press ENTER
Terminal config
Trm3 None — Ok?No
Trm2 None —
Trm1 01 Pr
P:11 Adr Priv/Shared
Display address
Controller address
Pr: Private
Sh: Shared
Sp
30 SysAer
Share the terminal for all the controllers:
²
The simplest way to configure a PLAN network is to give to the controllers the addresses from 1 to x
and to give to the display(s) the addresses 32, 31, 30 ….
²
Connect the 0-address display to the controller
previously chosen (powered or not). Once the
controller is started (25 seconds after power
up and after the Self test screen, then the
screen must be empty), press simultaneously
the UP, ENTER and DOWN keys, the following
screen will appear:
²
Press ENTER to enter the Display address setting field.
²
Change the display address by pressing the UP and DOWN buttons.
²
Press ENTER. If you have empty screen, or
NO LINK or Display Address changed, press
again the UP, ENTER and DOWN keys. By
pressing ENTER two times, you should be able
to modify the I/O Board address. Preferably,
put the address of the controller on which the
display is connected. Finally, you should see
the next screen (for example):
²
Press ENTER
²
Press ENTER as recommended
²
The following screen will be displayed:
