6-30
PDT 3400 Product Reference Guide
7. Place the PDT 3400 in a CRD 3400 office cradle.
When the office cradle is detected, IPL communicates with the cradle and sets it up
for IPL mode. The cradle LED should be blinking at this point.
8. IPL proceeds to erase the selected area and display the prompt:
Waiting to REC
ROM Disk X
115200
to indicate that the PDT 3400 is ready to receive data, and 115200 is an example of
the baud rate selected.
Continue the Send on the PC
1. If you are using TCM, choose the OK button to proceed with the send.
If you are using HEX2TERM, press <
Enter
> on the PC to begin the transfer. Don’t
wait longer than 5 minutes to press the key or a time-out occurs and you will have
to start the process over again.
2. The PDT 3400 displays the following screen:
RECEIVING XXXX
where XXXX is the byte count transferred.
When the BIOS or ROM Disk is loaded, the PDT 3400 displays the following
message:
CHECKING DISK X
Download Successful
If the download is successful, the PDT 3400 displays:
DOWNLOAD DONE
HIT TRIG KEY
FOR IPL MODE
The cradle re-initializes and stops blinking
Summary of Contents for PDT 3400 Series
