Symbol PDT 3400 Series, Product Reference Manual

Page: 99 / 146

8-3
Terminal Configuration: Running BIOS Setup
Note: Only four lines of the Menu are displayed at a time. Use the and
keys to scroll up and down through the fields.
The PDT 3400 times out if no entries are detected. Press PWR to
restore the Setup screen.
5. To change the values in a field, press the Scan Bar which scrolls forward through the
range of possible values.
a.
Time . In 24-hour format. To set hours or minutes, highlight the appropriate 00
and press the Scan Bar to increment hours/minutes until the correct time is
displayed.
b. Date. Enter a date in MM / DD / YY format. Setup scrolls through each segment of
the field in sequence. To change a segment, press the Scan Bar while that segment
is highlighted to increment the month, day, and year until the correct date is
displayed.
c. Contrast . Range is 0 - 7. Values at either end of the range (0 or 7) can make the
screen difficult to read. Default is 3.
d. Keyclick . Determines whether the keyboard “clicks” each time a key is pressed.
Default is ON.
e. Suspend . Sets the time in which the display times out if no activity is detected, in
increments of 5 seconds. Range is 0 -1275. A value of 0 disables the timer. Default
is 30 seconds.
f. Reset . Sets the length of time that the Power key must be pressed to cold boot the
PDT 3400 in increments of 4 seconds. Range 4 - 64. Default is 12 seconds.
g. Boot Sequence . Sets the default boot sequence. The choices are C: (ROM Disk)
or A:. Default is C.
h. Volume . Sets the beeper volume. The choices are low or high. Default is low.
i. Lamp . Sets the backlight on or off. Default is off.
6. Once all parameters are set, highlight MAIN MENU and press Scan Bar to exit.
7. From the Setup Menu, select EXIT.
é
ê