Symbol PDT 3400 Series, Product Reference Manual

Page: 89 / 146

6-31
Terminal Configuration: Building and Sending the Hex Image
Download Failure
If the download fails, the PDT 3400 displays the message:
“Download Failed!
ROMDISK #1
and includes a message indicating what the error was. These error messages include:
Press < Enter > to return to the IPL Main Menu.
Error Message Action to Take
Erase Error Previous contents in flash not erased. Reattempt the download.
Line Stat Err Reattempt the download.
Baud Too High Change the baud rate to a lower setting and reattempt the download. See
Set the Communications Parameters for information on setting the baud
rate for a particular script in TCM; see IPL Setup or Setup for Download
Using HEX2TERM for setting the baud rate in IPL or HEX2TERM.
Image Corrupt Retry the download. If download fails again, bring up the script in TCM
and run Build again, then reattempt the download. If you continue getting
the error, call the Symbol Support Center for assistance.
Wrong Area You may be attempting to download a BIOS to an area in flash other than
the one reserved for the BIOS, or a hex image to the area reserved for the
BIOS. Verify the type of image being downloaded and target area in flash,
then reattempt the download.
Image Too Big File exceeds the flash capacity. Review the hex image contents, resize the
image (see Set the Script Parameters), run build again, and reattempt the
download.
Not Hex File Verify that the file being sent is a hex file and reattempt the download.
Write Error Reattempt the download.
Checksum Error Reattempt the download.
Verify Failed Reattempt the download.
Unable to Contact
Cradle Check the cradle’s power connector and reattempt the download.