SWM SM 125 R 2020, Quick Manual

Page: 46 / 162

OUTLAW 125
12 / EN
INSTRUCTIONS FOR USING THE MOTORCYCLE
STARTING THE ENGINE
After getting on the motorcycle as described in
the relative paragraph, operate as follows to start
the engine:
1) Place ignition key (1) to position (the buzz
that you hear when you turn the key to is
caused by the fuel pump which puts the feeding
system under pressure);
2) pull the clutch lever (2);
3) shift gear pedal (3) to neutral position then
release the clutch control level;
4) check that the button (4) is in position and
then press the start button (5).
WARNING*:
Do not run the cold motor with a high number
of revs.
Note*: A safety switch is set on the clutch lever
support. This switch allows you to ONLY start the
engine with the gearbox idle, or with the gear
engaged and the clutch lever pulled.
With the stand lowered, the bike can only be
started with the gear in neutral.
1
2
N
3
4
5
R.H. HANDLEBAR SWITCH
The right-hand switch features the following
controls:
1) Engine start button
Pressing the button (1) with the key in
position and the switch (2) in position, the
engine starts.
2) Engine KILL SWITCH.
Flicked to position, disables engine starting
and running.
Flicked to position, enables engine starting
and running.
L.H. HANDLEBAR SWITCH
The left-hand switch features the following
controls:
1) High beam flasher (self-cancelling)
2) High beam
Low beam
3) Left-hand turning indicators
Right-hand turning indicators
To deactivate the turning indicators, press the
control lever after it is returned to the Centre.
4) Warning horn
COMBINED BRAKING CONTROL
The combined braking control pedal (1) is
located in the motorcycle right side. A stop
switch, when braking, causes the taillight lamp
ignition.
NOTE
If you pull the lever (2) you’ll brake using the
front brake; if you press the pedal (1) a
combined braking, for which the system will
divide the braking, both on the front brake and
on the rear one, will occur.
2
1
1
2
3
4
1
2