Swift Motorhomes 2013, Owner'S Service And Warranty Handbook

Page: 98 / 205

FITTED EQUIPMENT
96
OPERATING INSTRUCTIONS
S 3004 (P) heating system
a = Operating handle (thermostat)
b = Piezo pressure switch (S 3004 P)
c = Blind cover
d = Integrated panel for a Truma fan
TEB-3
e = Sensor button to switch on the lighting
(optional)
f = Auto ignitor with battery compartment
(S 3004)
g = Mica window to observe the flame
h = Thermostat sensor
i = Type plate (removable case!)
Note: The illustration shows installation on
the right. For installation on the left, the parts
are arranged on the other side (mirror-
image).
To operate
S 3004 P with piezo pressure sitch
1. Open gas cylinder and quick-acting valve
in the gas supply line.
2. Turn the operating handle (a) into
thermostat position 1-5 and push down as
far as possible. Press the ignitors in quick
succession at the same time until the
flame burns.
3. Hold down the operating handle (a) for
up to 10 seconds so that the safety pilot
responds.
4. Watch another 10 seconds through
the mica window whether the flame is
extinguished by the air in the line (caused
by gas cylinder change).
!
Never re-ignite before waiting
another 3 minutes otherwise there is
danger of deflagration!
This also applies
if a heating system already in operation
goes out and needs to be re-ignited.
If the gas supply line is filled with air, it can
take up to two minutes until the gas is
ready to burn. Keep the operating handle
pressed down and keep pressing the
pressure switch until the flame burns.
5. In order to achieve even and quick
distribution of warm air and reduction of
the surface temperature at the outlet grill
for warm air, we recommend that the
heating system is operated with the Truma
warmer running.
Note: The S 3004 P heating system (with
piezo pressure switch) is constructed so that
subsequent installation of an auto ignitor is
possible (part no. 30580-01).
TRUMA S 3004 SPACE HEATER