Swift Motorhomes 2013, Owner'S Service And Warranty Handbook

Page: 118 / 205

FITTED EQUIPMENT
116
A
8. *LPG bottle full / empty
This function is used in
combination with the cylinder
changeover (DuoComfort or
Secumotion) and indicates if the
LPG bottle is full or empty. This
function can also be used to
control defroster heating of the
cylinder changeover using an
EisEx defroster.
Note: The cylinder changeover (DuoComfort
or DuoControl) must be installed in order for
this function to work.
9. Automatic temperature
increase (legionella)
At 02.00 at night (if the clock is
set) the boiler starts and works
according to “Warm Water” (see
section 5). This is in order to
reduce the risk of legionella. The
function is disconnected in the
factory setting
10. Offset (temperature
adjustment)
Using this function, you can
calibrate the temperature on
the panel if you notice that the
temperature (the stabilised room
temperature) is not the same as
the temperature shown on the
panel. This also applies to outdoor
temperature
11. Button sound
With this function, you can
connect or disconnect the button
sound. The button sound is
connected in the factory setting.
12. Luminance
The luminance can be adjusted
between 1-10. The factory setting
is 2.
13. Language
This function is used to reset
the screen between different
languages. Available languages
are: English, French and German.
On the other hand, the service
menu is only in English (see
section 10.1).
14. Tools / Key
Under Tools / Key you can lock or
unlock access to the tool menu.
15. *External start
This function is used when starting
the boiler from the outside,
for example, with GSM. When
external start has been activated,
the control panel’s On/Off button
must be switched off (see the
assembly setting manual for
external start).
Note:
To use this function, an external start
installation is required.
*230 V
This function is used in connection
with starting the boiler when
connection of 230 V to vehicle
takes place from outside. When
the 230 V function has been
activated the control panel’s on/off
button must be turned off, but
12 V must be connected (main
switch on). Before turning off
the control panel with the on /
off button set the parameters/
functions that you want the boiler
ALDE 3010 CONTROL PANEL