Svantek SVAN 979, User Manual

Page: 326 / 377

326
SVAN 979 User Manual - Appendixes
Table C.5.2. Pin out of the LEMO ENG1B307
Contact no. Signal name
1 Preamplifier temperature meas. Input
2 Power GND
3 +200V Polarisation Voltage
4 Signal Input
5 Extension Cable ID Input
6 +28V Supply Voltage
7 Signal GND
Connector body Shield / Cable Screen
Power supply
Instrument is dedicated for the operation from the internal replaceable battery.
Power consumption from the 6V source is approx. 190 mA (at + 20

C)
So, typical operating time from 4 x AA alkaline batteries will be about 9.5 hours .
SVAN 979 can be also powered from the AA Type rechargeable batteries.
Note: For temperatures below 0

C operating time can decree (depending on the batteries)!
Note: Using of the USB Flash Disk (memory Stick) will increase power consumption. Maximum power
consumption on the USB Host Port might be up top 150 mA. In such a case battery operating time
will be reduced to approx. 6 hours!
Instrument can be also powered from the external source (e.g. SA 17A or car battery) with the DC Voltage
from 6 V to 24 V.
Voltage ripple should not exceed

5%.
External Power requirement is voltage dependent:
for 6 V - 190 mA DC,
for 24 V - 45 mA DC.
Power Supply connector 5.5 / 2.1 mm (external view)
Table C.5.3. Pin out of the power supply connector
Internal Pin 5.5/2.1
Shield Ground
1
+ 6 V

24 V