Suzuki LT-Z400, Service Manual

Page: 44 / 492

0B-18 Maintenance and Lubrication:
Brake pedal height inspection and adjustment
1) Inspect the brake pedal height “a” between the pedal
top face and footrest.
Adjust the brake pedal height if necessary.
Brake pedal height “a”
Standard: 0 – 10 mm (0 – 0.4 in)
2) Loosen the lock-nut (1).
3) Turn the push rod (2) until the brake pedal becomes
0 – 10 mm (0 – 0.4 in) “a” below the top of the
footrest.
4) Tighten the lock-nut (1) securely.
Tightening torque
Rear brake master cylinder rod lock-nut (a): 18
N·m (1.8 kgf-m, 13.0 lb-ft)
Parking brake inspection and adjustment
Inspect and adjust the parking brake cable length “a” as
follows.
Parking brake cable length “a”
47 – 51 mm (1.9 – 2.0 in)
1) Loosen the parking brake adjuster lock-nut (1) while
holding the adjuster (2) with a wrench.
2) Loosen the adjuster (2).
3) Loosen the parking brake cable adjuster lock-nut (3).
4) Turn the cable adjuster (4) so that the cable length
“a” is 47 – 51 mm (1.9 – 2.0 in).
5) Tighten the adjuster lock-nut (3).
6) Turn the adjuster (2) clockwise until stops.
7) Then turn the adjuster (2) 1/8 – 1/4 back.
8) Tighten the adjuster lock-nut (1) while holding the
adjuster (2) in position with a wrench.
Tightening torque
Parking brake adjuster lock-nut (a): 18 N·m (1.8
kgf-m, 13.0 lb-ft)
CAUTION
!
After adjusting the parking brake, check that
there is no dragging when turning the rear
wheel with the wheel off the ground.
“ a ”
I933H1020043-02
2
(a)
1
I933H1020044-01
“ a ”
I933H1020045-01
1
2
I933H1020046-01
4
3
I933H1020047-01
2
(a)
1
I933H1020048-02
PartShark.com
877-999-5686