Suzuki DR 125, Service Manual

Page: 96 / 222

3-60 ENGINE
• Tighten the cylinder head cover bolts to the specified torque
with a torque wrench diagonally.
$
Cylinder head cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
!
!
CAM CHAIN TENSION ADJUSTER
Install the cam chain tension adjuster following the procedure
below.
• After loosening the locknut
1
, loosen the set screw
2
one
turn and fully insert the push rod
3
into the adjuster body.
Lock the push rod
3
by tightening the set screw
2
.
• Install the cam chain tension adjuster to the cylinder and
tighten its mounting bolts to the specified torque.
$
Cam chain tension adjuster mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
!
• Turn the crankshaft normal direction, and stop it at exhaust
valve operating position.
• Loosen the set screw
2
one turn.
• Tighten the set screw
2
to lock the tensioner push rod and
then tighten the locknut
1
to the specified torque.
$
Cam chain tension adjuster locknut:
12 N·m (1.2 kgf-m, 8.5 lb-ft)
KICK STARTER LEVER
• Install the kick starter lever.
Install the gasket washer to the bolt
A
.
Be sure to check the valve clearance. (
&
2-5)
Replace the gasket with a new one.